- Question for guys with Aftermarket Cams
- Just ordered Livernois 1C cam kit, now have question?
- Magnacharge/turbo/supercharger
- Anyone using Vision motorworks catch can?
- Strut tower brace with supercharger
- squeak when cold started
- Livernois 1C cam kit and Dod deleter plus more install!
- Serpentine belt tensioner problems
- How to add 5 mpg?
- Mobil1 5W-30
- Building another engine.
- L76
- Livernois Stage 1 Cam
- Fuel Efficient Parking????
- How to get push back in your seat wow feel?
- Next Step(s)??
- RPMs jump when coasting around 45 mph
- Map Harness connector
- Map wire colors?
- Help!!!!
- FAST 102? LS3? intake for 434ci Stroker??
- difference between 223/231 .610 . 617comp and vengeance cam
- LS2 Vette AC Compressor... anyone?!
- Stock Fuel Pump Finally Dumped, now I need help?
- Coolant bleed
- RPM's@ 70 MPH
- Cam/DoD delete dummy - Help!
- Oil Pressure On Atari Gauge is 1 at idle
- Smaller cam = Slower time 12.89@109
- Magnacharger, Procharger or Turbocharger?
- Just got done getting a dyno done
- Livernois 416
- RPM related Vibration.
- Help Dyno numbers arent what they should be
- Engine Squealing/Chirping....cant take it any longer
- Head porting in Chicago?
- Burnt oil smell while driving....
- P0556/P0557 and occasionally P2544
- New G8 GT owner, have a couple questions
- AFM Cam????
- CAT Melt Down?
- New puzzling sound upon startup
- Knocking help
- Not noticeable more power after cam swap...
- Help with L76 build.
- Power Steering Line problems
- 7.0 topend on a L76 shortblock?
- Squeling...
- New Generation Maggie?
- Camaro SS LS3 swap into G8 GT
- not enouph mods?
- Oil life
- DOD cam still around?
- new cam specs and quote
- DoD/AFM?
- Help! Motor stopped while driving.
- Today the g8 comes to life!!
- Dumb Question
- Looking for info on GXP mods
- L76 question
- Cam selection
- is the belt tensioner covered under 5/100k powertrain
- Experience with L76 Head Milling
- Are you still happy with your Livernois Stage 1 Cam?
- Click here to listen to my Birthday Present
- Comp Blower Cam
- DOD or bad motor?
- Belt Dust
- Powerplant discussion.
- Non-DOD Cam Install - Tips, Tricks, and Traps
- What thermostat is in Pontiac G8 GT?
- Cam -lifters
- Catch can issues
- Goodyear Radiator Hoses - Do they fit?
- Cam, Heads, Torque converter, build
- L76 Engine
- Tighten Oil drain plug
- Dyno Results with new Pat G Cam
- Oil Pressure Sender Cover?
- DOD problem
- Thrown codes
- Dealer didn't add correct amount of oil??!
- Heads or cam?
- local rookie..
- Intermittent stumble from a dead stop
- LS3 Throttle Body?
- Mods versus track times
- Valvetrain clatter. DOD issue?
- Finally got some track times.... and they suck.
- LS7 cam in GT while retaining DOD
- Troubleshooting help needed after head gaskets and studs install
- Plugs?
- What Mod should come next??
- Another engine issue??
- Squealing/Whining under the hood
- Performance parts
- Two Codes This Morning P1825 and P0700
- What cam with converter
- Input Needed: Steps after installing Cam/DoD
- Nick Williams 102 tb
- Supercharger hp numbers?
- Cam or supercharger???
- Catch can needed on Stock engine?
- Tick Tick Tick.....
- new g8 gt... need tips
- Those that have replaced cam...step in.
- What GM Vehicles have the L76
- P1400 code
- Livernois Stage 1 Installing This Week!
- Texas Speed DOD/AFM delete
- Milling Factory Heads
- Knocking?
- DOD cam replacement, now 2nd gear surging
- Transmission specialities - would you recommend
- HELP! I am stumped. Issues after cam swap on friend's G8 GT
- what does "surging" mean?
- crankshaft timing issue getting codes; p0335, p0336
- No more tick on start up after oil change.
- Tuner recommendations
- Oil pan gasket replaced without oil change!
- Big cam - surge/low vacuum issues
- 2,500 Miles over Oil Change, Still have 47% Oil Life
- Modification vs reliability
- Finally installed RotoFab 102mm intake AND maf!
- Lots of liquid (water?) coming out of exhaust
- New Motor
- Head, tb, intake porting worth it???
- Strange smell from oil
- Metal shavings in motor oil. Need some advice.
- Heater hose relocation
- Help! Check engine light after hptuners read
- Help! Loud noise at start up
- Thinking about adding oil cooler
- Lunati Link Bar Lifters
- Those with an udp...
- Have a little $$$ to spend, but want to do this right this time.
- Bored of my 223/231 .610/.617
- g8 gt - where would i land with cia, cat back, and 87 oct tune
- Best Bolt-on Method to Increase Torque
- Engine Squeak
- Little oil change = Big repair!
- Harmonic Balancer going to be replaced.
- 1.5 (2 bars) = lb's oil pressure?
- Thinking about a Livernois stroker
- Custom supercharger cam or LS9 cam?
- MPG problem. Maybe running rich
- need help slp harmonic balancer
- This will work, right? (Nitrous wiring questions)
- reset oil life?
- Oil leak and strut bushings
- calling Patrick G!
- Safety Mode and Reduced Power
- Ls2 heads vs l92 heads...
- Another dod delete help thread
- May have a dumb question about vendors doing head work...
- I have a question about head porting.
- P1 to D1
- whats the best cai tune combo out there
- Fuel Injectors???
- Questions regarding some cam specs...
- LS3 Supercharger on L76
- P1SC ProCharger + 9-10psi = issues?
- Piston Slap??
- rear main repeat offender
- Low RPM vibration
- need some help i am about to put alot of money into my car won
- @@ Heeelp plz ,,, S/C & pro on LS3 ? @@
- Lifters replaced under warranty
- Looking for opinions
- Cam without using a stall
- tentioner help!!!!
- can i run car after cam install before tune ???
- Why do my engine starts on 7 cylinders with block heater use.
- Finished vms 2.5 cam install
- Water Pump out at 16K.
- I want to FORGE!
- ported intake and throttle body gains?
- Help with Procharged G8
- Ticking noise when engine is cold
- what ports do i use for catch can, 1900 & LS3
- AFM Not activating after a trip to the dealer
- anyone here use Schaeffer Oil?
- Modded Car with no Catch Can?
- How much is too much?
- Ticking in my LS3
- Pros vs cons
- What's the best option? CAI, or Tuner?
- Fuel Injector Cleaner
- My Car Sounds Like its Supercharged
- Furious would be an understatement right now..
- Map Sensor - will LS2 style work in L76?
- Lifter Tick? Humor me please, I'm paranoid.
- Just In....Norris Motorsports Catch Can and Ported Throttle Body
- quantifying upgrades to the L7Y
- Spun Bearing?
- Stock LS3 cam in L76?
- Anyone use the Katech Billet Belt Tensioner?
- g8gt owners what is your horsepower with cam and headers ...
- MY next move...YOUR opinion
- $11,000 but no motor
- P0521 code(EOP sensor performance) now wierd noise (rod?)
- ZL1 Fuel Pump - Installed and Dyno tested
- Odometer check with mods
- Something different
- G8 brother in need of some help!
- what is this sound? am i tripping out?
- tuners
- Best rockers?
- Parts on the way!!!!!!!
- Supercharging Questions
- Has anyone upgraded rockers while keeping stock cam?
- Factory Shop Manuals where to get ?
- Who is running 12psi + stock cam/heads?
- In Afgan, planning
- LS9 springs and 1.85 RR's
- L76 Stock Camshaft LSA?
- Electric Cutouts
- spun my crank shaft bearing
- Cam
- Need CAM Advice/Input: Newbie
- How do these cars hold up with high miles?
- AC belt gone, I am the latest victim...
- Chevrolet Lumina SS Underdrive Pulley
- Upgrade springs and retainers on stock cam?
- What cam is right for me....?
- Nice Used TVS2300 on eBay
- Bent Pushrod!
- Anyone install a gmpp ls9 supercharger?
- Cam/ DOD delete kit- help me choose
- Minor oil consumption, it fixed itself, believe it or not . . .
- First mods...noob
- LTs with GXP mufflers
- cheap engine mods ?
- Went for oil change and got a spun bearing
- Great Livernois Experience
- Installing headers next weekend, should I change my plugs?
- Powerbond UDP Parts List
- New Cam coming in tomorrow
- Which oil filter do you use?
- cam for 08 caprice
- GT L76 Motor Chirping - Need Help ASAP
- Possible Knock
- Nitrous questions....?
- Possible lifter tick
- White plastic piece
- Looking for some HP Gains
- p0521, help me troubleshoot
- Harmonic Balancer - wobble?
- Lifters collapsed, repairs declined
- Suggested Reading?