Anyone know of a vendor producing these for the G8? Gt of course!

I searched here and google and came up with nothing.

Cheers

Anyone know of a vendor producing these for the G8? Gt of course!

I searched here and google and came up with nothing.

Cheers

I am interested this as well.

I would assume (though I could be wrong) that an underdrive pulley for any of the recent GM small blocks would work.

:gears:hi you there in the us in regards ,about underdrive pulleys try some of the tuning shops here in australia .I have bought one here in australia through a company called precison balancers try google search cant remeber what i pay for it here in australia cheers from oz

http://www.lingenfelter.com/store/941024.html
http://www.lmperformance.com/6629/74.html

Sweet!

Thanks guys!

I know a lot of these parts are carried over from other models and engines but are we SURE that they aren't different? I'd hate to spend 2-3 hundred on something from Oz that doesn't fit...

I'll check it all out.

Thanks again!

Actually I don't think any of those listed so far will work. Powerbond( the company fact co named above) the company that SLP uses for their pulleys which are made in Ausiland, has a specific and separate application for the commodre ve, which is the same as the G8. The part numbers are as follows-
PBU1117-SS10 <-10% under
PBU1117-SS25 <-25% under

i am not sure if any us dealers have them in stock yet. You can contact new era who is a vendor on here who is a powerbond dealer.

Here is a link to the actual catalog if anyone is interested-
http://www.precisionparts.com.au/Pages/Applications/Powerbond2008_singles.pdf

Actually I don't think any of those listed so far will work. Powerbond( the company fact co named above) the company that SLP uses for their pulleys which are made in Ausiland, has a specific and separate application for the commodre ve, which is the same as the G8. The part numbers are as follows-
PBU1117-SS10 <-10% under
PBU1117-SS25 <-25% under

i am not sure if any us dealers have them in stock yet. You can contact new era who is a vendor on here who is a powerbond dealer.

Here is a link to the actual catalog if anyone is interested-
http://www.precisionparts.com.au/Pages/Applications/Powerbond2008_singles.pdf

Doesn't the VE use the LS2 though, while the G8 has the L76?

I was looking at my pulley's and notice we need a two belt design pulley.

I've pulled the stock pulley off to look at it. It is a vette spacing pulley however theres a wierd oil seal at the end of the snout. not sure what its for so I didn't put the pulley on.