mj_duell
06-27-2008, 09:51 AM
http://www.clubcobra.com/classifieds/data/2/large/ffr_pic_019.jpg
http://www.clubcobra.com/classifieds/data/2/large/ffr_pic_013.jpg
Factory Five Cobra (Mark II) with only 3800 miles, Assembled in 2005. Painted in metallic blue with pearl, street quality paint job. The engine is a 5.0-liter Ford with a Vortech Supercharger. The interior is riveted aluminum, but I have the complete carpet kit, trim and the period style harnesses that came with the car. I also have the badges if needed. The car is in great condition and runs very well. This car is already titled and was registered in Massachusetts so it will be a breeze to get on the road. Here are the cars specs:
Engine: 5.0L EFI
Polished Vortec V1 6psi blower -straight cut gears - FMU
Polished Trick flow Intake
Stock heads and cam, new rings/bearings/oil pump/chain
EGR Eliminator
70mm TB
75 MM Pro-MAF
Adj. Fuel pressure regulator
190 LPH Fuel pump
Ceramic coated headers and side pipes
Aluminum Radiator
Accusump with electronic valve and stainless braided lines.
Twin remote oil filter and braided lines.
Mocal Oil cooler and thermostat
Trans:
T5 5spd with FMS clutch disc and flywheel
Al clutch quadrant
Pro 5.0 shifter
Wheels:
5 lug PS Engineering Halibrand Replicas with
Nitto NT 555 tires 245/45R Front, 275/45R Rear
Brakes:
Front 11" Lincoln rotors
Rear Forte disc conversion 10.65"
Aluminum Jeep Master cylinder (polished and ball milled)
Wilwood prop valve
Suspension:
3 link with coil-overs
Tubular rear LCA
Mustang front LCA with Energy suspension bushings
Rear 3:55 FMS gears and new clutch pack
8.8" aluminum Differential cover
Interior
Vinyl Seats and FFR carpet to be installed
Autometer Gauges
Wipers
3 AC pedals
Windshield mounted side mirror
Finishing Details:
Polished Al upper radiator hose with F panel block off plate
Billet lower radiator hose mount and pet****
Louvered engine bay panels
Polished Al blower mount to significantly clear FFR frame
Hood hinge (.090" molded horseshoe with hiem joints) The only FFR part is the gas shocks
Steering wheel center
Steering shaft cover
Roll bar upper bolt eliminator
Aluminum alternator mount for driver side
License plate light contacts to eliminate exposed trunk lid wiring
approx. 360h.p. wieght: 2400lbs. The engine has not been dyno'd.
$26,500.00 O.B.O cash or certified funds.
I have the title in hand. I am available by phone for questions. Mike (585) 415-6701
http://www.clubcobra.com/classifieds/data/2/large/ffr_pic_013.jpg
Factory Five Cobra (Mark II) with only 3800 miles, Assembled in 2005. Painted in metallic blue with pearl, street quality paint job. The engine is a 5.0-liter Ford with a Vortech Supercharger. The interior is riveted aluminum, but I have the complete carpet kit, trim and the period style harnesses that came with the car. I also have the badges if needed. The car is in great condition and runs very well. This car is already titled and was registered in Massachusetts so it will be a breeze to get on the road. Here are the cars specs:
Engine: 5.0L EFI
Polished Vortec V1 6psi blower -straight cut gears - FMU
Polished Trick flow Intake
Stock heads and cam, new rings/bearings/oil pump/chain
EGR Eliminator
70mm TB
75 MM Pro-MAF
Adj. Fuel pressure regulator
190 LPH Fuel pump
Ceramic coated headers and side pipes
Aluminum Radiator
Accusump with electronic valve and stainless braided lines.
Twin remote oil filter and braided lines.
Mocal Oil cooler and thermostat
Trans:
T5 5spd with FMS clutch disc and flywheel
Al clutch quadrant
Pro 5.0 shifter
Wheels:
5 lug PS Engineering Halibrand Replicas with
Nitto NT 555 tires 245/45R Front, 275/45R Rear
Brakes:
Front 11" Lincoln rotors
Rear Forte disc conversion 10.65"
Aluminum Jeep Master cylinder (polished and ball milled)
Wilwood prop valve
Suspension:
3 link with coil-overs
Tubular rear LCA
Mustang front LCA with Energy suspension bushings
Rear 3:55 FMS gears and new clutch pack
8.8" aluminum Differential cover
Interior
Vinyl Seats and FFR carpet to be installed
Autometer Gauges
Wipers
3 AC pedals
Windshield mounted side mirror
Finishing Details:
Polished Al upper radiator hose with F panel block off plate
Billet lower radiator hose mount and pet****
Louvered engine bay panels
Polished Al blower mount to significantly clear FFR frame
Hood hinge (.090" molded horseshoe with hiem joints) The only FFR part is the gas shocks
Steering wheel center
Steering shaft cover
Roll bar upper bolt eliminator
Aluminum alternator mount for driver side
License plate light contacts to eliminate exposed trunk lid wiring
approx. 360h.p. wieght: 2400lbs. The engine has not been dyno'd.
$26,500.00 O.B.O cash or certified funds.
I have the title in hand. I am available by phone for questions. Mike (585) 415-6701