[vegas_ss]

I'm so happy, got them out in 5 minutes with this.

What is that tool? I have one with the head rounded out?

 

[vegas_ss]

I did try tapping in the torx bit with a hammer without any luck, now it's pretty rounded out. I may try the cutoff wheel or even using a dremel to cut a cross in it and try an impact phillips bit. The other three came out ok but certainly required more force than I would have expected. Should get back to it later in the week. Thanks for the suggestions.

 

[vegas_ss]

Thought I would update... got the bolt out fairly easily with an extractor... This is the kit I used and the 3/16" did the trick!

Extractor