Pontiac G8 Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
It's been awhile since I've had my G8 up on the lift. I'm trying to remember why a simple plate like the one shown in the picture below couldn't be made from 1/8" plate, then a coil mount bracket welded to it?

The bottom would just be a through bolt. Then size up the factory shock (extension & compression) and buy the correct size coil over and spring?

Coil spring Gas Nickel Household hardware Metal
 

· Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
I was doing some more reading. A short shock/spring wouldn't be good. My goal is to fab a setup that would be good for drag racing. I'm not into the stance stuff.

Well, back to the drawing board.
 
1 - 4 of 4 Posts
Top