Pontiac G8 Forum banner

1 - 1 of 1 Posts

6 Posts
Discussion Starter #1
In the process of building my turbo setup and was wondering if anyone has an oil cooler plumbed in to their oil feed/drain system. I’m looking at an oil cooler that has an adapter that replaced the block off plate and the adapter has an “in” and an “out”. This would be a much simpler option than pulling the pan to weld a fitting but I’m not sure if there would be any unforeseen issues. Thanks!
1 - 1 of 1 Posts
About this Discussion
0 Replies
1 Participant
Pontiac G8 Forum
A community for Pontiac G8 owners and enthusiasts, for all the information on your Pontiac G8 sedan, G8 GT, G8 V6, and G8 GXP. Discuss performance, tech, engine specs, body kits and more!
Full Forum Listing